Introduction: The nutrient powder production line is mainly used for the production of nutritional powders. It processes grains and other processed grains into powdered products through puffing under high temperature and high pressure and drying, crushing, and final mixing. At present, the nutritional powder production line has been widely used. Here we will introduce the common faults and treatment methods of the nutritional powder production line.

Analysis of common failures of nutritional powder production line

The common faults in the nutrient powder production line mainly include loss of control of the electric valve, uneven distribution of the material, and rotation of the electric valve motor while the valve is not rotating. The specific conditions and treatment methods of the nutrient powder production line above are:

Electric valve out of control. When this happens, check for any foreign matter stuck in the valve body. If it is found, remove it immediately. The material level detection device is not in the proper position. It needs to be repositioned properly. The sensor switch on the electric valve is damaged or improperly positioned. Replace the new sensor switch or adjust the mounting position. The material is not uniform. The exclusion method for this situation is to correct the levelness of the two ends of the forming roller, whether there is a gap between the squeegee and the forming roller, and if necessary, the upper fastening bolt needs to be adjusted. The electric valve motor rotates and the valve does not rotate: In this case, replace the new coupling or tighten the coupling fixing bolts.

The nutrient powder production line should be operated in strict accordance with the correct operation method during the use process, and the production workers who use the nutrient powder production line should be trained to use scientific operations to minimize the failure of the nutritional powder production line during use.

On the basis of thick film heater, our company developed the stainless steel welding interface Heating Element in order to meet the customers` needs of variety applications, this type of heating element can withstand 0.8 MPa pressure, it is a best choice for coffee machine, instant water heater, industrial water heating equipment and other products.


bearing pressure thick film heater



It is assembled by Thick Film Heating Tube, protective housing, thread interface welding connector, over temperature protection system, NTC, temperature senor and sprial column.


spare parts of bearing pressure heater



Power Density is up to 60W/cm2.

Temperature ramp-up between 80℃~150℃/S.

Electric Heating Circuit printed on tube surface`s insulation layers, and covered by another insulation layer. Water and Electric is insulated totally.

Thermal transfer efficiency ≥98%.

Long work life( > 10000H ) 

Environment and Health friendly: Non-electromagnetic radiation and heavy metal ions

Simple Structure & Compact Profile brings more possibility for new products R&D.

It can successfully replace Traditional Electric Heating Tubes/Elements, change their structures and performance completely, which can reduce energy consumption, increase energy utilization and save space.

advantage of bearing pressure thick film heater


Bearing Pressure Thick Film Heater

30Mm Stainless Steel Welding Heater ,Welding Treatment Heater,Stress Relief Heat Treatment,Pwht Procedure For Carbon Steel

XINXIANG JIEDA PRECISION ELECTRONICS CO.,LTD , https://www.tubularheater.de