Today, many electronic factories have purchased security gates to conduct electronic component safety inspections. Essentially, they are mainly used for theft prevention. After all, they are valuable for some precious parts, not all employees can do it. Abiding law, this is a practical problem!

So, how should the electronics factory maintain such equipment during the use of metal security doors? Today, the peacekeeping era technology to answer this question for everyone:

Since electronic factories use metal detection doors for a long time, they will all be turned on during working hours. This is a big job for equipment. How do you maintain it?


1, after work at night, strive to close the security door, because the security door is an electronic product, long-term power at night, first, the aging rate increases, after all, any parts in the power state, will slowly aging, too long, naturally reduced performance.

2. It is not safe to power at night! Although there are security controls inside the security door to enhance the internal chip security control to prevent damage to the chip because of excessive current, but if you encounter thunder and lightning weather, high-voltage power may burn the motherboard chip may, this way, you need Changing the chip brought unnecessary losses and troubles.

3. Keep the surrounding environment of metal security doors dry and have less dust. The security inspection equipment uses a wooden material as a frame, because the wooden material does not bring about metal detection interference, and the light weight is suitable for use. However, this kind of material is not easy to use in a humid environment for a long time. In addition, where there is too much dust, it can easily enter the interior through the ventilation holes of the main chassis, rapidly aging the internal chip of the main chassis and causing malfunction.

The above three points are the precautions in the process of using the security door in the electronic factory. It is possible to properly maintain the equipment. An excellent quality equipment can be used for many years!

Construction Machinery Solenoid Valve Coil

The category of Solenoid Valve Coil used in construction machinery Solenoid Valve, such like excavator, truck, trailer, and so on.


1. Solenoid Coil range in hole diameter from 5 mm to 28 mm, more bigger is available.
2. Common AC and DC voltages (6V DC, 12V DC, 24V DC, 36V DC, 48V DC, 24V AC, 110V AC, 115V AC, 220V AC, 230V AC, 240V AC) are all available, others can be customized.
3. Many termination options are available.
4. Using high quality wire which has UL approved;
5. Using high quality permeability magnetic material which contain low carbon
6. Using high quality housing material like PA66, PBT, PPS, BMC and so on.
7. Insulation class can be B, F, H, N, C;
8. Protection class can be IP65, IP67 & IP69K;

Construction Machinery Solenoid Valve Coil,solenoid valve coil for excavator,solenoid valve coil for truck,solenoid valve coil for trailer

NINGBO BRANDO HARDWARE CO.,LTD , https://www.brandopneumatic.com