Inferior filter damage to construction vehicles

In the intake system of an engineering vehicle engine there is a filter which consists of one or more clean air filter elements. His main function is to filter out the harmful impurities in the air that will enter the cylinder, such as dust particles, garbage, etc., which can reduce the wear of cylinders, pistons, and piston rings on the engine of the construction vehicle. What are the damages to the construction vehicle caused by the inferior filter?

The use of low-price filter paper to produce filter elements, because of its large filter paper aperture, poor uniformity, low filtration efficiency, can not effectively filter out the harmful impurities of the engine, resulting in the engine car's early wear. The use of low-quality adhesives, and the use of very little, neither oil nor strong bonding, may cause short-circuit conditions at the filter joint; or use staples to connect the joints of the filter, can not be sealed and short circuit, so that a large number of harmful impurities Enter the engine to reduce engine life.

Parts of the air filter housing are mainly spot welds, which cannot guarantee tightness and cause short circuit damage to the engine. The thin material of the oil filter center tube material is not strong enough. In the process of use, the air in the center tube is sucked, resulting in damage of the filter element and blocking of the oil circuit. As a result, the engine's lubrication effect is insufficient; or the viscosity at the mouthpiece is not reliable. In the course of use, the mouth is torn apart, which causes the oil to leak in a short time, thus causing burning of the tiles and holding the shaft.

The metal parts such as the end cap of the filter element, the center tube, and the shell are not subjected to rust-proof treatment, resulting in metal rust corrosion and impurities, and the filter becomes a pollution source. What's more, using cement instead of adhesives is more harmful. On the other hand, in the daily use of the filter, if there is a blockage or excessive dust accumulation, it will cause the engine to air intake is not smooth, and a large amount of dust enters the cylinder, it will accelerate the cylinder carbon deposition speed, so that the construction vehicle engine ignition is not Smoothness, lack of power, and resulting in increased fuel consumption of the vehicle.

Therefore, the use of inferior filters costs a lot, it is recommended that users should be careful when replacing filters. It is better to use the original parts of the construction vehicle manufacturer or the filters produced by the regular manufacturers to avoid unnecessary economic losses to the construction vehicle engine. (Wen/Jun Xun)

WHATSMINER

HONY WhatsMiner SHOP

M30S++ 100/102T,M30S++ 104T,M20S 68T,M21S 56/58T,M31S 76/78T,M32S 68T

Hony Engineering Plastics Co.,Ltd. , https://www.honyplastic.com