Frangible paper seals are typically lower cost and are often used on higher volume applications including retail products, medications, confidential documents, etc.Fragile laser security sticker: this type of holograms is impossible to be removed undamaged. We can make hologram embossing on the surface of the labels and white paper can be used on the back side instead. (You see, nowadays, the conventional surface of this label is silver hologram and the back side is silver hologram as well.) Our special method in making fragile sticker can be conducive to the clean and tidy of the products and can not be counterfeited as well. Frangible Paper Seals,Fragile Laser Security Sticker,Frangible Paper Security Label Shenzhen Tuteng Anti-Counterfeiting Co., Ltd. , https://www.holographicsticers.com
1) Determination of installation location a. Close to the drive position and install on the same side of the electrical equipment.
b. Keep away from the violent vibration area and try to avoid the source of the cream warm.
c. Pay attention to the convenience of maintenance.
2) Select a suitable suspension method a. Select the appropriate type and size of the suspension bracket according to the site conditions;
b suspension spacing standard length 1200mm. Up to 20000mm;
3) Installation Precautions a. According to the installation diagram, determine the position of functional sections such as the power supply section and the expansion section, and number them according to the installation location.
b. Install the first slide. It must be suspended by a fixed suspension to serve as a benchmark for alignment across the board.
c. The first slide conduit should be adjusted to have a parallelism of less than 1.5mm/1000mm with the centerline of the running track of the electrical equipment. The subsequent installation of the slide wire ensures the straightness of the first slide and the operation of the electrical equipment. The straightness of the track is not more than 1.5mm/1000mm.
d. For the DHGJ type slide wire must be effective to ensure a good grounding performance of each slip line.
e. After the installation is complete, it should be rechecked on the entire line. When the first installed slide wire (catheter) is not used as a check reference, it can be replaced by a floating hanging clamp.
f. Check the safety installation condition to ensure that the parallelism of the rails of the entire line and the power-consuming equipment and the straight line of the slide wire (catheter) itself is not more than 15mm.
g. Installation of the collector stack. Note the matching of the long and short legs of the catheter.
h. The final power-on operation, found that the problem was resolved immediately.
Sliding line installation: